Just BrainDumps

Question No. 1

Refer to the exhibit.

You are implementing Fibre Channel smart zoning, and you need to prevent RSCN

events. Which two configurations use the hardware resources efficiently? (Choose two.)

• A. a Cisco UCS Fibre Interconnect that uses Fibre Channel switch mode
• B. the NPIV feature enabled upstream
• C. the NPV feature enabled upstream
• D. a Cisco UCS Fibre Interconnect that uses end-host mode
• E. storage that is directly attached to the Cisco UCS Fabric Interconnect

Question No. 2

In Cisco UCS Manager 2.2 or later, in order to manually boot from the FlexFlash SD card, which boot option must be in the boot policy used in the service profile?

• A. remote virtual drive
• B. FlexFlash state
• C. SD card
• D. remote boot

Question No. 3

Which three parameters can be configured for a vHBA? (Choose three.)

• A. Enable persistent binding.
• B. Enable a hardware-based failover.
• C. Define a SAN pin group
• D. Assign a QoS policy.
• E. Define an MTU.
• F. Assign a MAC address.

Question No. 4

Which three items represent some of the components to implement Cisco VM-FEX for Cisco Unified Computing System Manager B-Series blades? (Choose three.)

• A. Cisco VSM VM
• B. VEM installed on the VMware vCenter server
• C. VEM in the VMware ESX or ESXi host
• D. Cisco Unified Computing System Manager version 1.2 or higher
• E. VMware vCenter server
• F. Fibre Channel VMFS volume

Question No. 5

Which three tasks can a user with the ext-lan-policy privileges perform? (Choose three.)

• A. Configure management interfaces on the fabric interconnect.
• B. Configure Ethernet pin groups.
• C. Configure management interfaces monitoring policy.
• D. Create/modify/delete vNIC/vHBA placement policies.
• E. Configure DNS providers and DNS domain.
• F. Specify the allowed range for virtual MAC addresses.
• G. Configure fabric interconnect system name.
• H. This privilege has full access to all operations.

Question No. 6

You have a Cisco UCS C220 M4 Rack Server that has five physical hard drives and is integrated with Cisco UCS Manager You need to use two drives to configure RAID 1 and use the three drives that remain to configure RAID 5 Which three steps do you perform to accomplish this goal? (Choose three.)

• A. Create an Any Configuration local disk configuration policy
• B. Create a local disk configuration policy for a RAID 6 striped configuration that has dual parity
• C. Configure the volumes by using the LSI tools outside of Cisco UCS Manager
• D. Create a local disk configuration policy for a RAID 5 stnped configuration that has parity
• E. Create a local disk configuration policy for a RAID 1 mirrored configuration
• F. Assign the local disk configuration policy to the associated service profile of the server

Question No. 7

Which options is the only supported link aggregation protocol on Cisco UCS Manager?

• A. Multipath
• B. PagP
• C. FLOGI
• D. LACP
• E. FCOE

Question No. 8

Which two items can you provision in a vHBA Template? (Choose two.)

• A. Max Data Field Size
• B. SCSI I/O Queues
• C. FCoE VLAN
• D. vHBA Interrupt Mode
• E. Stats Threshold Policy
• F. FLOGI Timeout

Question No. 9

Refer to the exhibit.

Interface Ethernet 1/30 connects to which type of switch?

• A. an FCoE switch that has NPV enabled
• B. a Fibre Channel switch that has NPV enabled
• C. a Fibre Channel switch that has NPIV enabled
• D. an FCoE switch that has NPIV enabled

Question No. 1

You must upgrade a Cisco UCS -Series Server. Where must the Cisco UCS bundle image be located before you can begin the upgrade?

• A. the Cisco Integrated Management Controller memory of the server
• B. a USB drive connected to a Cisco UCS Fabric Interconnect
• C. a TFTP server accessible to the Cisco UCS Fabric Interconnect
• D. the flash file system of the fabric interconnect

Question No. 2

You plan to use AAA security services for a Cisco UCS Fabric Interconnect.

Which two authentication protocols can you use? (Choose two.)

• A. NTLM
• B. Kerberos
• C. RADIUS
• D. Diameter
• E. LDAP

Question No. 3

Which adapter is capable of supporting VM-FEX?

• A. VIC 1280
• B. Cisco UCS M61KR-I
• C. Cisco UCS M72KR
• D. Cisco UCS M51KR-B

Question No. 4

Which of the Mowing do you use to update the board controller firmware?

• A. local disk
• B. infrastructure firmware
• C. server pool
• D. host firmware package

Question No. 5

Refer to the exhibit.

From the Cisco Integrated Management Controller GUI, the Cisco Network Assistant VIC adapter properties of a Cisco UCS -Series Server in standalone mode are configured as shown. Which three options are results of the configuration? (Choose three.)

• A. Sixteen dynamic vNICs on the Cisco Network Assistant VIC adapter are provisioned.
• B. A description for the Cisco Network Assistant VIC adapter is assigned.
• C. Sixteen static vNICs on the Cisco Network Assistant VIC adapter are provisioned.
• D. FIP support on the Cisco Network Assistant VIC adapter is enabled.
• E. Sixteen dynamic device aliases for vNICs on the Cisco Network Assistant VIC adapter are provisioned.
• F. NIV mode for the Cisco Network Assistant VIC adapter is disabled.

Question No. 6

Which three statements about what occurs when a Cisco UCS -Series Blade Server connects to the SAN across a fabric interconnect that is enabled in Fibre Channel NPV mode are true? (Choose three.)

• A. The server ports in F Port mode are pinned to the NP Ports.
• B. The E Ports are pinned to the E Ports on the fabric interconnect.
• C. Zoning is deployed on the fabric interconnect.
• D. The fabric interconnect is not assigned a Fibre Channel domain ID.
• E. Traffic that is received on the server ports in F Port mode from the server side is pinned to the NPIV-enabled uplink ports on the fabric interconnect.
• F. The fabric interconnect must have the Fibre Channel uplink port connected to the upstream switch F Port in NPIV mode that performs the Fibre Channel forwarder function.

Question No. 7

Refer to the exhibit.

Which statement is correct?

• A. The flapping interval is 20 minutes
• B. The flapping interval is 20 seconds
• C. Data is retained for 24 minutes
• D. Data is retained for 24 hours

Question No. 8

Which consideration must be made while utilizing the UEFI boot mode?

• A. Legacy boot modes cannot be used on the same server.
• B. This mode applies only to models before the M3.
• C. The service profile cannot be disassociated without decommissioning the blade.
• D. This mode replaces the UEFI shell typically available as a boot fallback.

Question No. 9

Refer to the exhibit.

What statement is true regarding this setup created by this configuration?

• A. The NIC bypasses the kernel when sending and receiving networking packets
• B. The applications interact directly with the OS Kernel
• C. All of the other vNICs in the server are deleted and replaced by the usnic.