Cisco 200-105 Practice Exam Questions

The 200-105 exam is associated with CCNA Routing and Switching Certification. Your success in this exam matters a lot to get certified.

Try it Latest DumpsSchool 200-105 Exam dumps. Buy Full File here: (691 As Dumps)

Download the DumpsSchool 200-105 braindumps from Google Drive: (FREE VERSION!!!)

Question No. 1

Which two statements about eBGP neighbor relationships are true? (Choose two.)

Answer: A, B

Question No. 2

What two options are causes of network slowness that can result from inter-VLAN routing problems? (Choose


Answer: B, E

Causes for Network Slowness

Packet Loss

In most cases, a network is considered slow when higher-layer protocols (applications) require extended time

to complete an operation that typically runs faster. That slowness is caused by the loss of some packets on the

network, which causes higher-level protocols like TCP or applications to time out and initiate retransmission.

Hardware Forwarding Issues

With another type of slowness, caused by network equipment, forwarding (whether Layer 2 [L2] or L3) is

performed slowly. This is due to a deviation from normal (designed) operation and switching to slow path

forwarding. An example of this is when Multilayer Switching (MLS) on the switch forwards L3 packets between

VLANs in the hardware, but due to misconfiguration, MLS is not functioning properly and forwarding is done by

the router in the software (which drops the interVLAN forwarding rate significantly).


Question No. 3

Which two data link layers are supported by Cisco IOS Software for IPv6? (Choose two.)

Answer: B, E

Question No. 4

Refer to the exhibit.

Some 2950 series switches are connected to the conference area of the corporate headquarters network. The

switches provide two to three jacks per conference room to host laptop connections for employees who visit

the headquarters office. When large groups of employees come from other locations, the network

administrator often finds that hubs have been connected to wall jacks in the conference area although the

ports on the access layer switches were not intended to support multiple workstations.

What action could the network administrator take to prevent access by multiple laptops through a single switch port and still leave the switch functional for its intended use?

Answer: D

Question No. 5

Where must you configure switch-level global features on a switch stack?

Answer: A

Question No. 6

If primary and secondary root switches with priority 16384 both experience catastrophic losses, which tertiary

switch can take over?

Answer: A

Question No. 7

Refer to the exhibit. A technician is testing connection problems in the internetwork. What is the problem

indicated by the output from HostA?

Answer: D

Question No. 8

Which router command can be used to verify the type of cable connected to interface serial 0/0?

Answer: B

Question No. 9

Which option describes a drawback of proxy ARP?

Answer: D

Question No. 10

Which command do you enter to protect a PortFast-enabled port against unauthorized switches on the


Answer: B

Question No. 11

The ROUTE company has a small network. The network consists of one switch and one router. The switch

has been configured with two VLANs. The router has been configured as a router-on-a-stick to allow inter-

VLAN routing. A trunk is configured to connect the switch to the router.

What is the minimum number of router subinterfaces that are required for all the VLANs to communicate?

Answer: C

Question No. 12

Which information is provided by the output of the show snmp engineID command?

Answer: B

Question No. 13

In which integration method is an IPv6 packet encapsulated within an IPv4 protocol?

Answer: D

Question No. 14

Which two characteristics of eBGP peers are true? (Choose two.)

Answer: A, E

200-105 Dumps Google Drive: (Limited Version!!!)

Related Certification: CCNA Routing & Switching dumps

Leave a Reply

Your email address will not be published. Required fields are marked *